RCA H5400RE3 Instruction Manual download pdf (Page 10)

Connecting the AC (Electrical) Power

Plug the power adaptor cord into the power jack on the

back of the base and the other end into an electrical

outlet. The charge/in use indicator turns on to indicate the

battery is charging when the handset is on the cradle.

Allow the phone to charge for 12 hours prior to ﬁrst

use. If you do not properly charge the phone, battery

performance is compromised.

CAUTION: Use only the 5-2652 power adaptor that came

with this unit. Using other power adaptors may damage

the unit.

Connecting the RF Module

Insert the RF module into the back of the base unit until

it snaps into place. The display wi l show when the RF

module is connected properly.

Registering the Handset

NOTE: Handset must be registered to the base to be

operational.

Once a handset is registered it can use the base phone’s

connection. A cordless handset will not operate until it is

registered to a base. During the registration process, keep

the handset near the base.

NOTE : At initial power up, display will show “PLEASE

proceed to step #4.

1. On the handset, press the MENU button once, and then

press the 4 button until REGISTRATION shows on the

display.

2. Press the SELECT/SAVE button or the STORE button to

select Registration mode.

3. Press the 3 or 4 button on the handset to select YES.

4. Press SELECT/SAVE to conﬁrm. The display shows

5. On the base, press and hold the PAGE button for 3

seconds. If the registration is successful, the handset

will emit a long beep.

6. If the registration fails, FAIL! TRY AGAIN will show on

the handset display. Please repeat the above steps.

Connections and Setup

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

No comments

RCA H5400RE3 Instruction Manual Page 10