RCA ANT3037XR Installation Manual download pdf (Page 10)

10

Remove the rubber boot from the matching

transformer. Slide the rubber boot over the

coax cable and install the connector. If your

coax cable has the connector already on it, you

will need to cut an X in the boot hole so that

the boot will slide over the connector. Attach

the coax cable to the matching transformer.

Then, connect the rubber boot to the body of

the matching transformer, as in Figure 15.

Mounting the Antenna

Place the mast clamp insert inside the mast

clamp so that the ﬂ at side of the mast clamp

insert presses against the boom. The holes in

both parts should align. Insert the ends of the

U-bolt through the holes. The mast should be

placed in-between the U-bolt and the mast

clamp insert. Thread a large nut on each end

of the U-bolt. Tighten the nuts until the U-bolt

securely holds the mast in place. The U-bolt

assembly will handle up to a 2.0” outer diameter

mast.

Helpful Tips

• Be sure the matching transformer is on the

bottom of the antenna.

• Point the front of antenna toward stations.

• Tape downlead to mast to prevent wind

whipping.

Fork

Rubber Boot

Figure 15

Figure 16

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments