RCA LCD User Manual download pdf (Page 38)

38 Chapter 4

Other Information

Mounting Your TV to the Wall

Caution: The wall mount must bear a minimum of ﬁ ve times

the TV’s net weight without causing damage.

Model L26WD12 comes packed with a wall mount plate. Models

L32WD12 and L37WD12 don't need a wall mount plate to attach the

TV to the wall. You simply purchase a VESA wall mount. Follow steps

1 and 2 below, then follow the instructions included with the wall

mount.

For model L26WD12, purchase a VESA wall mount that has mounting

measurements of 200mm horizontally and 100mm vertically. For

models L32WD12 and L37WD12, purchase a VESA wall mount that has

mounting measurements of 400mm horizontally and 200mm vertically.

To attach the plate (for model L26WD12 only):

1. You need to remove the base ﬁ rst in order to attach the plate.

A. Place the TV facedown on a surface that is soft, yet strong

enough to hold the TV.

B. Remove the two jack panel covers by pushing up on the tabs

and pulling the covers out carefully.

C. Use a screwdriver to remove the screws from the four holes on

each side of the TV’s base as the arrows indicate on the base.

2. Make sure all devices are already connected, then put the covers

back into place over the jack panels.

3. Locate the wall mount plate.

4. Attach the plate to the back of the TV with the four screws packed

with the wall mount plate.

5. Follow the directions included with the wall mount to mount the

TV to the wall.

Attach plate using these holes.

Remove the two jack covers to remove the

base.

Remove the screws from the four holes on

each side of the TV’s base.

Attach plate using these holes.

Wall mount plate (L26WD12 only)

Book 1.indb 38Book 1.indb 38 12/9/05 5:44:14 PM12/9/05 5:44:14 PM

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

No comments

RCA LCD User Manual Page 38