Rca CC9360 User Manual download pdf (Page 60)

Advanced Features

58 Chapter 5

Manual Menu

The following settings are available only in

(manual record mode).

System Menu

The following settings are available only in and

(manual record mode).

BEEP OFF Beeps are turned off and shutter sound is not heard.

BEEP Beeps sound when any operation is performed and shutter

sound is heard during snapshots.

MELODY Factory Preset: A melody is heard instead of a beep when any

action is performed and shutter sound is heard during

snapshots.

TALLY OFF The tally light remains off at all times.

ON Factory Preset: The tally light comes on to indicate the start of

a recording.

ID This number is necessary when connecting the camcorder to a

NUMBER device such as a computer using the service port. The numbers

range from 01 to 99. Factory preset is 06.

DIS OFF Factory Preset: Refer to Using Steady Pix™ (see page 37).

TELE OFF Factory Preset (OFF) : Usually the distance to a subject where

MACRO ON the lens is in focus depends on the zoom magnification.

Unless there is a distance of more than 1 m (3.3 ft) to the

subject, the lens is out of focus at the maximum telephoto

setting. When set to ON, you can shoot a subject as large as

possible at a distance of approximately 60 cm (2 ft.).

Depending on the zoom position, the lens may go out of

focus.

WIDE OFF Factory Preset: Doesn’t display black bars.

MODE

CINEMA Allows you to record black bars at the top and bottom of the

screen to produce a cinema-like wide-screen effect.

SQUEEZE For 16x9 aspect-ratio TVs. Naturally expands the image to fit

the screen without distortion.

WIND OFF Factory Preset: Sound is recorded as normal without preventing

CUT wind noise.

ON Cuts down on the noise created by the wind.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 107 108

No comments

Rca CC9360 User Manual Page 60