Rca ProV600 User Manual download pdf (Page 17)

15

Remote Control

Install Remote’s Lithium Cell

The remote’s lithium cell is packed

separately. Install it in the remote as

follows:

1. Turn the remote over, insert a pencil or

paper clip in the small hole, and slide

the cell holder in the direction of the

arrow to remove it.

2. Insert the cell in the cell holder so the

positive (+) terminal faces up.

3. Replace the cell holder in remote by

pressing in until it clicks into place.

Notes: Never place anything heavy on top of

the remote control or lay it upside-down.

Replace cell when camcorder fails to respond

to remote.

Remove cell from remote if it will not be used

for a month or more. This will prevent

possible damage from cell leakage. If leakage

occurs, wipe up liquid inside compartment and

replace cell.

Cautions: Lithium cell must be

disposed of properly. Never handle

punctured or leaking cell. May cause

burns or personal injury.

Keep out of the hands of children.

Can cause death or injury if

swallowed. If swallowed, consult a

physician immediately for emergency

treatment.

The lithium cell used in this device

may explode resulting in a fire or

chemical burn if mistreated. Do not

recharge, disassemble, heat above

212°F (100°C), or incinerate.

Never use metallic tweezers to hold

the cells, and never short circuit the +

and – sides of the cell.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 62 63

Comments to this Manuals

No comments