RCA RLC1909 User Manual download pdf (Page 10)

Remote Controller

POWER

MUTE

P.MODE S.MODE SLEEP

DISPLAYEXIT

SOURCE

MTS

ENTER

1010

3 0--9 Press 0~9 to select a TV channel directly while watching

TV. The channel will change after 2 seconds.Applicable for

entering page number in teletext mode and so on.

2 Press to mute the sound. Press again or pressMUTE :

VOL+ to unmute.

1 Sets your TV to power on or standby mode.POWER :

4 : Return to the previously viewed program.

5 Press to scan through or to select a channel.CH +/- :

6 Press to increase / decrease the sound level.V +/-:

7 -/-- Press this button to enter a program number for

different digit. eg. -/--/---

8 Press to display the source and channel's info.DISPLAY :

10 SOURCE: Press to list the source items.

11 SLEEP: Select amount of time before TV turn itself

off automatically.

12 E Exits from the menu or sub-menu and menus and adjustXIT:

the system settings to your preference.

13 MENU : Allows you to navigate the on-screen menus.

14 Press to cycle through the different picture settingsP.MODE:：

16 S.MODE: Press to cycle through the different sound settings.

15 Press to select the MTS mode.(for example,Nicam ,MTS:：

BTSC,MONO,STEREO .eg )

VOL

Universal Remote Control code:007F

Battery Installation:

Remove the battery compartment lid on the rear of the remote control by sliding the lid down, then

off. Put two AAA batteries inside the battery compartment with their + and - ends aligned as

indicated. Do not mix old and new batteries or different types of batteries Replace the battery

compartment lid. Slide the lid until you hear it click into place.

Using the Remote Control:

Unless stated otherwise, the remote control can operate all the features of the TV.

Always point the remote control directly at the remote sensor in the front of the TV.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

RCA RLC1909 User Manual Page 10