RCA F27450 User Manual download pdf (Page 11)

Chapter 2 9

Using the Remote Control

Use these buttons

when you program

the remote to

operate another

component.

The remote might

not operate all

brands or models.

STOP

ON OFF

AUX

SAT

CABLE

PLAYREVERSE

VCR1

VCR2

CLEAR

REVERSE Press REVERSE to go backwards on a videotape or disc.

SAT•CABLE Puts the remote in SAT•CABLE mode. If you set up the Auto Tuning feature (Chapter 3), pressing

the SAT•CABLE button tunes the TV to the correct channel.

SKIP If you press SKIP before you change the channel, the TV waits 30 seconds and goes back to the original

channel. Each time you press SKIP, you add 30 seconds. Press CLEAR to cancel skip timer.

SOUND Displays the AUDIO PROCESSOR menu.

STOP Stops playing a videotape or disc.

TV Turns on the TV and puts the remote in TV mode. Also displays channel information.

VCR1 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR1

button tunes the TV to the correct channel.

VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR2

button tunes the TV to the correct channel.

VOL (up and down) buttons Decrease or increase the TV’s volume.

WHO•INPUT In TV mode, press WHO•INPUT to toggle through the available Video Input channels (FRNT,

VID1/SVID1, VID2/CVID2, and the current channel). In SAT mode, press to select available channel lists.

Using the WHO•INPUT Button

Use the WHO•INPUT button to toggle through the available input sources (FRNT, VID1/SVID1, VID2/CVID2, and

the current channel) and view the content from the component you have connected to the TV.

1. Press TV to place the remote in TV mode. Make sure that the content from the component is turned ON.

2. Press WHO•INPUT to tune to the available input source and view the component.

3. Press WHO•INPUT again to tune back to the channel you were previously watching.

Programming the Remote to Operate Other

Components

The universal remote control can be programmed to operate most brands of remote

controllable VCRs, RCA audio receivers, satellite receivers and cable boxes. The remote

is already programmed to operate most RCA, GE and Proscan VCRs, DVD players, audio

receivers and satellite receivers.

Note: The TV and DVD buttons cannot be programmed.

Find Out If You Need to Program the Remote

To determine whether the universal remote needs to be programmed, turn a

component ON, such as a VCR, point the remote at the VCR, and press the VCR button.

Then press ON•OFF or channel up or channel down to see if the VCR responds to the

remote commands. If not, the remote needs to be programmed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

Comments to this Manuals

No comments

RCA F27450 User Manual Page 11

Comments to this Manuals

Related products and manuals for CRT TVs RCA F27450